Showing 81–111 of 111 results
6mm throater allows for precise adjustments to the reamer so you can ream to any desired throat depth. The straight portion of the cutter passes through a sliding bushing with a tapered shoulder at the front end. The bushing is precisely honed so that the cutter can rotate or move axially with ease, but lateral movement…
This reamer is neck only for 7mm caliber. Reamers are designed to provide a standard chamber for the specified caliber, that means the neck will normally be about .004” over the diameter of the loaded round. .3165″ diameter neck for chamber. NOTE: No gauges are available for shipment with this reamer.
7mm throater allows for precise adjustments to the reamer so you can ream to any desired throat depth. The straight portion of the cutter passes through a sliding bushing with a tapered shoulder at the front end. The bushing is precisely honed so that the cutter can rotate or move axially with ease, but lateral movement…
8mm throater allows for precise adjustments to the reamer so you can ream to any desired throat depth. Cuts up to 0.324 The straight portion of the cutter passes through a sliding bushing with a tapered shoulder at the front end. The bushing is precisely honed so that the cutter can rotate or move axially…
Threads onto the reamer to covert it to standard 7/16″ round shank with 3/8″ square drive flats.
Shotgun Choke and Forcing Cone Hone *Extra Hone stones, 240 grit. Can also be used on chokes.
This device is added to your chamber reamer to control the depth of your cut. The micrometer adjustment allows you to fine tune your chamber depth in .001” increments. Produced in the United States here in Michigan by Bauduin Accuracy and Machine. Download JB Reamer Stop Instructions
Precision, repeat-ability, and ease of use: these are the benefits of P. O. Ackley Micrometer Reamer Stop. Now you can do production runs with your Chamber Reamer, without having to index each workpiece axially. You’ll be assured of consistent headspace, chamber after chamber! To set up, insert your Chamber Reamer shank in the Reamer Holder…
By simply slipping the Plug Gauge into the barrel throat, it’s possible to tell at a glance when you are approaching the correct diameter. Warns you before you go too far. Also valuable as a diagnostic tool for guns brought in with accuracy complaints, (designed for chamfers cut with our tools – may not give…
Interchangeable pilot crowning tool for calibers from 22 to 6mm.
Interchangeable pilot crowning tool for calibers from 25-284 (7mm).
Interchangeable pilot crowning tool for calibers from 30-458 caliber.
Interchangeable pilot crowning tool for calibers from 30-458 caliber. Medium Radius
Comes with an adapter for standard 3/8″ square drive (as pictured), about 9 inches long. For use with most chamber reamers. Adapter can be removed to expose thread if you are using PTG or other tools that have a threaded drive end.
No products in the cart.
|
Uploaded
Failed
|
 |