5/8″ x 24 RH Die 5.45mm
for specific muzzle brakes.
Includes a thread alignment tool (TAT) Specify caliber at check out. When using a TAT make sure the tool never touches the end of the barrel, only the pilot.
If the TAT is allowed to touch the muzzle it is likely the tools will be damaged or you will damage your new threads.
You may also like…
Die stock – 1.5″$5.00
for use with 1.5″ diesAdd to cart
Muzzle Thread Protector$19.95 Add to cart
Tap Magic, cutting fluid, 4 oz. can
Tap Magic, 4 oz. can enough cutting fluid to do many jobs.Add to cart
Works as a chamber reaming cutting fluid.
Micrometer Reamer Stop$30.00
Precision, repeat-ability, and ease of use: these are the benefits of P. O. Ackley Micrometer Reamer Stop. Now you can do production runs with your Chamber Reamer, without having to index each workpiece axially. You’ll be assured of consistent headspace, chamber after chamber!
To set up, insert your Chamber Reamer shank in the Reamer Holder and tighten the two set screws. Then insert the reamer holder into the Stop Cylinder assembly (micrometer threaded Stop Cylinder with .001″ Adjustment Nut, Lock Nut and optional Plug Nut). Make a rough cut in the chamber (leave about .025″ extra material). Now, with the reamer bottomed in the rough chamber, move the Stop Cylinder assembly into contact with the work piece and secure it to the Reamer Holder with three set screws.
You can now adjust the depth of the finish cut in increments of .001″, or even less. The Adjustment Nut is marked with 25 equidistant markings around the circumference, each of which corresponds to .001″ of axial adjustment. By backing off the Adjustment Nut and re-securing the Lock Nut, then repeating the cut, you can zero in on your specified headspace measurement. Adjustments of .0005″ can be made with confidence.
We recommend use with our floating reamer holders for best results, with this rental.
.437″ straight shank for use in all Lathes and Mills.Add to cart