
Similar Posts
Do you have a print for that reamer?
There is a lot to learn about chamber prints. We recommend the post on this blog. We are asked for reamer prints on a daily basis. We have never provided them as they do not represent a specific tool. Prints are representative of what you would receive. Reamer makers like all machinists use tolerances when…
Learn About Pilot Fit, It Matters!
Pilot Diameter is Crucial

7.21 FireHawk, Lazzeroni
Designed by John Lazzeroni and introduced in 1996. This 7mm cartridge was dropped from the Lazzeroni line in 1999 when the 7.21 Firebird came out. It could push a 120 grain Barnes X at 3697 feet per second. As well as a 140 grain at over 3500 fps. We picked up the reamer for this…
Nosler Chamber Reamers & Gauges
Several years ago Nosler took nearly every caliber from 26 to 36 to SAAMI. As soon as they were approved we bought all the reamers and gauges. The 26 and 28 Nosler are the only cartridges that share the same headspace gauges in the Nosler factory line-up, all the others have their own specific gauges….

MEASURING FOR SCREW-IN CHOKES (Shotgun)
Before accepting a barrel for machining to accept screw-in chokes, you must measure the outside diameter (O.D.) to determine if there will be sufficient wall thickness after machining. “Mike” the O.D. of the barrel and the O.D. of the tap for the particular gauge. Subtract the O.D. of the tap from that of the barrel,…

Ackley Category Added to the Site
We have seen a ton of demand for Ackley calibers since the publication of Fred Zeglin’s two new books in 2017. For this reason we have created a category on the 4D web site to separate out all Ackley cartridges making them easier to find. They still appear in the standard caliber listings as well….