Cutter
Showing all 7 results
-
#2 60° Center Crown Cutting Tool
$28.00Interchangeable pilot crowning tool, 25-7mm caliber.
-
#3 60° Center Crown Cutting Tool
$28.00Interchangeable pilot crowning tool, .30 thru .49 caliber.
-
Annular Cutter – Muzzle Diameter Reduction .500″ x 1″
$42.00Annular Cutter* for reduction of muzzle diameter. Cuts 0.900″ max, diameter down to 0.500″ x 1″ deep for use so you can thread the muzzle for a brake, 1/2×32 or 1/2×28 .
Threading dies rent separately.
*Low RPM (250 RPM is Maximum) and lots of Lube, unless you want to replace the tool.
-
Annular Cutter – Muzzle Diameter Reduction .570″ x 1″
$42.00Annular Cutter* for reduction of muzzle diameter. Cuts 0.900″ max length, diameter down to 0.570″ x 1″ deep for 14x1LH as used on the SKS & AK pattern rifles or carbines. Threading dies rent separately.
Also works for 9/16-24 muzzle threading. Threading dies rent separately.
*Low RPM (250 RPM is Maximum) and lots of Lube, unless you want to replace the tool.
-
Annular Cutter – Muzzle Diameter Reduction .630″ x 1″
$42.00Annular Cutter* for reduction of muzzle diameter. Cuts 0.900″ max length, diameter down to 0.630″ x 1″ deep for use so you can thread the muzzle for a brake, 5/8 x 32 or 5/8 x 24 equally as well.
Threading dies rent separately.
*Low RPM (250 RPM is Maximum) and lots of Lube, unless you want to replace the tool.
-
Revolver Forcing Cone Tools 41 Caliber (22 degree)
$35.00Includes the 22 degree forcing cone cutter, rod, t-handle and bushing where needed. This cutter was made by PTG and fits our kits. They are marked 11 degree, but they are twice as steep as the Brownells 11 degree cutter. Results would likely be best with jacketed bullets.
Add an 11 to 18 degree chamfer plug gauge if you so desire, they work on the diameter of the forcing cone so would work for this cutter as well.
If you want a 90 degree cutter add that as a separate item here and indicate the diameter you need.
-
Revolver Forcing Cone Tools 44 Caliber (22 degree)
$35.00Includes the 22 degree forcing cone cutter, rod, t-handle and bushing where needed. This cutter was made by PTG and fits our kits. They are marked 11 degree, but they are twice as steep as the Brownells 11 degree cutter. Results would likely be best with jacketed bullets.
Add an 11 to 18 degree chamfer plug gauge if you so desire, they work on the diameter of the forcing cone so would work for this cutter as well.
If you want a 90 degree cutter add that as a separate item here and indicate the diameter you need.
