Receiver Tap – 98 Mauser Large Ring
Receiver Thread Tap (large ring)
You may also like…
Hawk Cartridges Manual$24.95
Hard cover reloading manual for Hawk Cartridges.
10 years of research went into the collection of data for Hawk Cartridges. This book includes all the data collected for all calibers. This unique line of wildcats is base on the concept of non-belted cartridges that deliver magnum velocities at pressures that are appropriate for the available brass. Most of the data includes pressure test results.
Fred Zeglin of Z-Hat Custom took the time to carefully assemble this data in a format that is useful to the reloader and student of ballistics.
Several articles both old and new are included to illuminate the Hawk Cartridge line-up. History and technical information, including how to form brass is all included. Very specific information about selecting correct brass for the cartridge you like.
Dimensions for all cartridges are included, no secrets here.
Everything you need to know to be successful with this line of Cartridges.Add to cart
for hand reaming or tapsAdd to cart
Manson Floating Reamer Holder$30.00
1/2″ straight shank for use in all Lathes and Mills.Add to cart
Micrometer Reamer Stop$30.00
Precision, repeat-ability, and ease of use: these are the benefits of P. O. Ackley Micrometer Reamer Stop. Now you can do production runs with your Chamber Reamer, without having to index each workpiece axially. You’ll be assured of consistent headspace, chamber after chamber!
To set up, insert your Chamber Reamer shank in the Reamer Holder and tighten the two set screws. Then insert the reamer holder into the Stop Cylinder assembly (micrometer threaded Stop Cylinder with .001″ Adjustment Nut, Lock Nut and optional Plug Nut). Make a rough cut in the chamber (leave about .025″ extra material). Now, with the reamer bottomed in the rough chamber, move the Stop Cylinder assembly into contact with the work piece and secure it to the Reamer Holder with three set screws.
You can now adjust the depth of the finish cut in increments of .001″, or even less. The Adjustment Nut is marked with 25 equidistant markings around the circumference, each of which corresponds to .001″ of axial adjustment. By backing off the Adjustment Nut and re-securing the Lock Nut, then repeating the cut, you can zero in on your specified headspace measurement. Adjustments of .0005″ can be made with confidence.
We recommend use with our floating reamer holders for best results, with this rental.
.437″ straight shank for use in all Lathes and Mills.Add to cart