T Handle Reamer Extension (1/4″ round shank)
Approximately 9″ long, Comes with an adapter for standard 1/4″ round drive with set screw.
Most commonly used with standard throat reamer and rim-fire reamers.
$10.00
You may also like…
-
Adapter for Precision Neck & Throat or Precision Throat Reamers
$5.00Threads onto the reamer to covert it to standard 7/16″ round shank with 3/8″ square drive flats.
Add to cart -
Manson Floating Reamer Holder
$30.001/2″ straight shank for use in all Lathes and Mills.
Add to cart -
Micrometer Reamer Stop
$30.00Precision, repeat-ability, and ease of use: these are the benefits of P. O. Ackley Micrometer Reamer Stop. Now you can do production runs with your Chamber Reamer, without having to index each workpiece axially. You’ll be assured of consistent headspace, chamber after chamber!
To set up, insert your Chamber Reamer shank in the Reamer Holder and tighten the two set screws. Then insert the reamer holder into the Stop Cylinder assembly (micrometer threaded Stop Cylinder with .001″ Adjustment Nut, Lock Nut and optional Plug Nut). Make a rough cut in the chamber (leave about .025″ extra material). Now, with the reamer bottomed in the rough chamber, move the Stop Cylinder assembly into contact with the work piece and secure it to the Reamer Holder with three set screws.
You can now adjust the depth of the finish cut in increments of .001″, or even less. The Adjustment Nut is marked with 25 equidistant markings around the circumference, each of which corresponds to .001″ of axial adjustment. By backing off the Adjustment Nut and re-securing the Lock Nut, then repeating the cut, you can zero in on your specified headspace measurement. Adjustments of .0005″ can be made with confidence.
We recommend use with our floating reamer holders for best results, with this rental.
.437″ straight shank for use in all Lathes and Mills.
Add to cart
