Revolver Forcing Cone Tools 38/357/9mm (22 degree)
Includes the 22 degree forcing cone cutter, rod, t-handle and bushing where needed. This cutter was made by PTG and fits our kits. They are marked 11 degree, but they are twice as steep as the Brownells 11 degree cutter. Results would likely be best with jacketed bullets.
Add an 11 to 18 degree chamfer plug gauge if you so desire, they work on the diameter of the forcing cone so would work for this cutter as well.
If you want a 90 degree cutter add that as a separate item here and indicate the diameter you need.
$35.00
You may also like…
-
Plug Gauges for Forcing Cones in Revolver Barrels
$6.00By simply slipping the Plug Gauge into the barrel throat, it’s possible to tell at a glance when you are approaching the correct diameter. Warns you before you go too far. Also valuable as a diagnostic tool for guns brought in with accuracy complaints, (designed for chamfers cut with our tools – may not give a correct reading on guns with other degrees of chamfer). Each gauge is self-piloted, precision-ground, hardened and stepped to show minimum and maximum optimum diameters. 11° and 18° Gauge measures both chamfer angles.
Select options
Instruction for Plug Gauges.
-
MGW Sight Pusher: 1911
$28.00Fits most any 1911 slide.
Designed to remove, install, and adjust the rear sight and not mar the handgun.
Add to cart -
AR-15 Barrel Wrench / Multi-tool
$10.00Multi-Tool you will need when assembling your AR.
Add to cart
