Pillar Drilling Jig by Score High Gunsmithing
This stock drilling jig is by far the best method for drilling a Remington 700 stock to accommodate our adjustable pillars or pillars made by any one. Each kit comes with a specially modified drill that will not split or damage the stock. The drill bushing bar is the same diameter as a Remington action and is rigidly attached to the stock. It is actually a superior method to drill a stock than a drill press or even a milling machine. We only stock the 5/8″ drill and bushings.
No more damaged finish trying to remove the factory trigger guard from a bedded stock. No more trying to clean epoxy and mold release from the rough surface of a factory trigger guard. Our bedding blocks leave the bedded surface of your stock looking as if it just came out of a precision mold. Because these Bedding Blocks are made extra tall you never have to worry about the factory trigger guard being slightly below the stock’s finished surface and what to do with the epoxy that runs over the top.
Instructions included in the rental.
You may also like…
Remington 700 Pillar Bedding Gunsmith Kit$49.95
Remington 700 Gunsmith’s pillar bedding kit comes with a set of adjustable pillars and installation tools for a perfect job every time. Full instructions included. refill pillar kits available separately. Just add your favorite bedding compound.Read more
Heat Sink, Remington 700$6.00
Heat sink for use in Remington 700 Bolt.Add to cart
Bedding Pillars, Rem 700$24.95
Remington 700 adjustable pillars. Buy stand alone or use to refill the Gunsmith’s pillar bedding kit.Add to cart
Forster Inletting Guide Screws (Stock Making)$8.95
These simple tools allow you to keep the barreled action properly aligned in the stock during the inletting process. Without them it is very difficult to get a tight inlet.
- 98 Mauser
- Springfield 03, 03-A3 and Krag actions
- Enfield 1914, 1917 and SMLE
- CZ 550 or 7.7 Jap Arisaka
- Remington 700, 721, 722
- Winchester 70 or 54