Annular Cutter – Muzzle Diameter Reduction .500″ x 1″
Annular Cutter* for reduction of muzzle diameter. Cuts 0.900″ max, diameter down to 0.500″ x 1″ deep for use so you can thread the muzzle for a brake, 1/2×32 or 1/2×28 .
Threading dies rent separately.
*Low RPM (250 RPM is Maximum) and lots of Lube, unless you want to replace the tool.
$42.00
You may also like…
-
9/16″ x 24 tpi LH die for FN FAL
$18.00Left hand die, for FN FAL muzzle, uses 1.5″ round die stock
Add to cart
Includes a thread alignment tool (TAT). When using a TAT make sure the tool never touches the end of the barrel, only the pilot.
If the TAT is allowed to touch the muzzle it is likely the tools will be damaged or you will damage your new threads. -
14 x 1 RH Die
$18.00Right hand thread for metric Flash Hiders or Muzzle Brakes
Add to cart
Includes a thread alignment tool (TAT) 7.62 Russian. When using a TAT make sure the tool never touches the end of the barrel, only the pilot.
If the TAT is allowed to touch the muzzle it is likely the tools will be damaged or you will damage your new threads. -
Die stock – 1.5″
$5.00for use with 1.5″ dies
Add to cart
